Yazar "Kabir, Sarower" seçeneğine göre listele
Listeleniyor 1 - 2 / 2
Sayfa Başına Sonuç
Sıralama seçenekleri
Yayın Influence of drilling parameters on the delamination and surface roughness of insulative-coated glass/carbonhybrid composite(Hindawi, 2023) Kabir, Sarower; Ahmad, Faiz; Shahed, Chowdhury Ahmed; Günister, EbruDrilling in synthetic fiber-reinforced polymer composites is facing challenges due to their anisotropic, inhomogeneity, and abrasive machining behavior. The joining of composite parts using fasteners is commonly done by the drilling, and the generated heat is one of the main causes to damage the drilled hole in the composite. Moreover, the quality of drilled hole is crucial for joining parts effectively. The paper presents the design, fabrication, and drilling of a hybrid fiber-reinforced polymer (HFRP) based on insulative coating. These composites were fabricated using vacuum infusion molding (VIM) and coated with different thicknesses to investigate the influence of drilling parameters and associated damages. Cutting speed, feed rate, and coating thicknesses were varied, and a full factorial design of the experiment was formulated. High-speed steel (HSS) twist drill bit was used to drill the coated composite and test samples, and delamination factor and surface roughness were measured. ANOVA and full factorial response optimizer were used to evaluate the influence and optimum drilling parameters. The delamination factor (DF) at the entry and surface roughness were found to decrease with the increasing cutting speed. However, the DF at the exit showed the opposite. Coating thickness influenced the delamination at the entry whereas delamination at the exit has been found insignificant. For drilling HFRP composite with 1 mm coating thickness, 3000 RPM spindle speed and 0.08 mm/rev feed rate were found optimum parameters in minimizing surface roughness and delamination damage. However, 6000 RPM and 0.02 mm/rev were found optimum parameters for drilling HFRP composite with 1.5 mm coating thickness.Yayın Process parameter optimization of laser beam machining for AISI -P20 mold steel using ANFIS method(Elsevier, 2025) Eaysin, Abdullah; Kabir, Sarower; Günister, Ebru; Jahan, Nur; Hamza, Amir; Zinnah, Muhammad Ali; Bin Rashid, AdibAISI P20 mold steel is commonly used for injection molds to produce plastic materials, car accessories, and electronic equipment molds. This study employed a fiber laser beam for precise machining of AISI P20 mold steel. The experimental design, based on the Taguchi 27 model, was carried out using Minitab software to optimize machining parameters, including cutting speed, gas pressure, and laser power. Surface roughness (Ra) and kerf width were the response parameters investigated. The ANFIS model, developed and analyzed using MATLAB, successfully predicted response parameters and was experimentally validated, showing improved predictions over actual measurements. The Brute Force algorithm identified the minimum combination for an optimal parameter set. The Taguchi method determined the best process parameters, indicating that cutting speed had the most significant impact. The optimum Ra was achieved with 1 m/min cutting speed, 2 bar gas pressure, and 1.8 kW laser power, while the lowest kerf width was obtained with 2 bar gas pressure, 1 m/min cutting speed, and 1.9 kW laser power. Based on the Brute Force algorithm, the minimum combination resulted in a kerf width of 0.84 mm and a surface roughness of 4.48175 μm. Microstructural analysis was performed on samples with high and low surface roughness to assess the machining surface quality.